Fluorescent and with reflective tape. Has a water-repellent finish. ULTIMATE STRETCH fabric that is lightweight and durable. Fastening with a zip. Detachable ID card holder. Chest pocket. Phone chest pocket with flap. Two detachable holster pockets at the front and two holster pockets at the back. Rear holster pocket can be buttoned up out of the way. Press stud fastening on innermost hanging tool pocket. Holster pocket with lined phone pocket and magnet fastening. Holster pockets with Kevlar® and CORDURA® fabric reinforcements. Tool strap at both sides of waist. Zipper adjustment at both sides. Ventilation in the back. Ventilation at the sides and with waterproof zips.
As the product is made of stretch material, a stretchable transfer must be used when printing on the product. You should choose a transfer that can be heated to a maximum of 145 degrees when being printed onto the product. Remember to check the washing instructions for the chosen transfer before washing the product.
The product is certified with a maximum logo area of 0,2500m². This approved area must not be exceeded. Logos respectively on the front or back of the product, can only constitute a maximum of 50% of the total approved logo area in order to maintain the EN ISO 20471-certification. Note: The listed area is only a guide to how much space is available for logo placement. In order to maintain the product’s hi-vis class according to EN ISO 20471, the instructions on logo size must be observed.
Logo placement::
- Workwear logo stretch. Over left breast pocket. Max 9x3 cm/3.5x1.1 inches
- Workwear logo stretch. Right breast pocket. Max 10X3 cm/3.9x1.1 inches
- Workwear logo stretch. On the nape. Max 12x3 cm/4.7x1.1 inches
- Workwear logo. Special placement. Contact to discuss further